Question:
Q. Is it possible to use ArtForm400 as a forms solution from other platforms than the AS/400 (I-series)
Answer:
A. YES.
ArtForm400 offers the possibility of either:
Converting a ASCII print file to SCS and then using ArtForm400 for both formatting the spool data and
adding a form. (APF3812/CVTPCLSPLF)
or
Merging a ASCII print file with a Form only. This means that ArtForm400 only adds a Form to the ASCII print
file. (Remember to use *INPUT as font selection in the main definitons of the overlay).
(Limitations: Copies and Duplex is not supported with this option).
